ETA Systems PD8 1U Rack Mount Conditioned Power Distribution

Description

You are bidding on (1) ETA rack mount power conditioner and power distribution unit.  It is used but in perfect working order.  Very little wear and tear.
This item was part of a rack system and has lived in a foam lined case for its entire life.  It was used by professionals and well cared for.
Manufacturer's Information:
INTRODUCTION
ETA Systems’ line of Conditioned Power Distribution Units are designed to prevent electrical damage to sensitive electronic equipment from high amplitude/short duration spikes, random surges, and EMI/RFI noise, which is inherent in utility power lines. Power line sources which are not preconditioned or filtered can affect reliable operation of sensitive audio, computer, and other electronic equipment, and may cause premature failure, expensive repairs, or unanticipated replacement from non-repairable damage. As inherent problems in utility AC power lines increase for various reasons, and the need for noise-free, conditioned power increases, ETA is there with the units to protect your valuable electronic equipment. With present demands on the power utilities, voltage spikes, power surges, electrical noise, and power failures are commonplace. This “garbage” in the power delivered can reduce the fidelity of audio systems, cause premature failure, or result in extensive damage or destruction of electronic equipment. ETA Conditioned Power Distribution units feature a master power switch, conveniently located on the front control panel, that switches the rear panel AC outlets ON and OFF. An LED next to the master power switch indicates the power conditioning circuitry is working and the rear panel AC outlets are powered. Maximum total wattage input is 1800 watts and the 8 power output receptacles are protected with a 15 amp (total unit) resettable circuit breaker.
Note: The front panel LED is normally lit when the power switch is in the ON position. If the power switch is ON and the LED is not lit, power may still be present on the output AC receptacles, but the power conditioning circuitry is not working. Do not continue use of the power conditioning unit and refer trouble-shooting to a qualified electronic technician or contact ETA Customer Service for assistance.
EASY INSTALLATION The PD8 and PD8L are easily mounted into a standard 19" rack or placed into a free-standing position. With the PD master power switch in the OFF position, plug the line cord into a convenient AC receptacle. Place the power switch into the ON position and check that the front panel LED is lit. The lit LED indicates conditioned and filtered AC power is connected. Then, with their master power switches in the OFF position, plug the equipment to be protected into the Power Distribution Unit’s rear panel AC receptacles. Turn ON the power switches of the equipment plugged into the ETA Power Distribution Unit.
FEATURES
• 15 Amp Input – Breaker Protected
• 8 AC Outlets
• Surge Protection Alarm
• Spike, Surge, and EMI/RFI Filtered
• Watchdog Protected Circuitry with “Go / No Go” LED Display
• Rack Illuminators (PD8L Only) • 1RU