48 Volt Battery Charger Golf Cart 48V 6A For golf carts and scooters 3pin

Description

This is an Automatic Charger with Trickle Mode in order to not overcharge your batteries and keep them running stronger for longer.  This is a 6amp Charger and is designed for overnight charging.  (depending on your batteries condition). This is a great charger that will not break the bank and that will get your cart up and running once again so you it can spend more time on the golf course than in the garage
Whats Included:
1 x New CLUB CAR 48 VOLT BATTERY CHARGER
1 x CLUB CAR 3 Pin Charge Plug STYLE PLUG
1 X POWER CORD
Unplug the charger if it hasn’t automatically shutoff in 14 hours:
The charger is designed to turn off when the voltage of the battery pack reaches a certain level. I have found that some battery packs don’t always reach the required trigger voltage and the charger remains on in a trickle charge mode.
If this happens, unplug the charger from the wall outlet, your cart should be fully charged. Most of the times after the charger has completed a few charge cycles the charger will begin to operate automatically.
The charger operating in the manual mode will not harm your battery pack, you will just have to manually disconnect the charger after the required charge time of not more than 14 hours.
How to Bypass the Club Car On-Board Computer
Your Club Car has an on-board computer for the single purpose of turning on or off your Club Car charger. When the batteries are fully charged the computer tells the Club Car charger to remain off. Or when the batteries are in need of charging the "OBC" On-Board Computer tells the Club Car charger to turn on.
With the purchase of this charger the on-board computer is no longer needed. Our chargers are fully automatic. The microprocessor within the charger senses the voltage level of your Club Car’s batteries and turns on or off automatically. The procedure to bypass your Club Car’s computer is simple and will take very little of your time. By bypassing your Club Car’s computer you are avoiding the future expense of purchasing a new computer just to charge your batteries.
The diagram above gives a detailed visual of your Club Car’s setup and the wiring needed to bypass your on-board computer.
Follow the directions below and you will be ready to use your new battery charger:
The negative line coming from the back of your charger-handle receptacle
The wire that you must install to bypass your computer.
You need only to splice into #1 with #2, no need to cut the line. Then connect the other end to the negative of the rear most battery; furthest back on the driver’s side (Same as shown above). Now your Club Car is ready to work with your new fully automatic charger.